Only 3 left in stock
The Water Level Sensor for Haier Top Loading Washing Machines (2 Pins) is a premium-grade replacement pressure sensor that accurately detects and regulates water levels during wash cycles. Designed for stable performance, long durability, and perfect compatibility with selected Haier top-load models, this spare part ensures efficient wash quality and protects the machine from under-filling or over-flow issues.
Care Instructions: Kindly install the spare parts with the help of a qualified technician.
Important Note: Kindly match your old parts with the given image for compatibility before placing the order.
A faulty Haier water level sensor can affect washing quality and machine performance. Check for these symptoms:
Incorrect Water Level – Tub fills too much or too little.
Machine Not Starting Wash Cycle – Stays stuck at the filling stage.
Error Codes on Display – Water level or pressure-related error shown.
Continuous Water Inlet or No Water Intake – The machine doesn’t stop filling or doesn’t fill at all.
Spin Not Working – Washer does not switch from wash to spin due to incorrect level detection.
If you observe any of these issues, your Haier washing machine water level sensor may require replacement.
⚠ Always consult a qualified technician for installation.
Disconnect Power Supply – Switch off the machine and unplug it.
Open the Rear/Top Panel – Locate the pressure sensor near the control panel.
Remove the Old Sensor – Detach the air hose and disconnect the 2-pin connector.
Install the New Sensor – Connect the air tube securely and attach the 2-pin wire plug.
Reassemble the Panel – Fit back the top cover and tighten the screws.
Test the Machine – Run a quick wash cycle to verify accurate water level detection.
This 2-pin sensor is compatible with selected Haier top-load models. Always match the old part with the product image before ordering.
It detects the water level inside the drum and signals the control board to start or stop water intake.
The machine may overfill, underfill, stop mid-cycle, or display error codes.
Installation should be performed by a qualified technician to avoid incorrect fitting or further damage.
Please note : We are Dealer of Home Appliances and Electronics Components Spare Parts. We sell only Premium Quality and Genuine Spare Parts Product in our Store. THANK YOU
Note: Please send photos of the ordered parts (old damaged parts) via WhatsApp after placing the order so that we can match the parts and send the correct product.
Only 3 left in stock
You must be logged in to post a review.
Reviews
Clear filtersThere are no reviews yet.